How to build the RBA correctly

RBA is a rebuildable atomizer. such as Eleaf LEMO 3 Atomizer and SMOK TFV8 Baby Tank.
1. Be sure your hands are clean.
2. Disassemble the RBA deck.

3. Install and seat the Pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten them to secure the coil. Be sure the coil is fixed in the center and that the coil is lined up with the airflow hole. Make sure that the coil is NOT touching the base.
4. Clip the excess leads from your coil.
5. Prepare you cotton, not too much but also not too little.
6. Insert the cotton and thread it through the middle of the coil.
7. Cut the ends of cotton at an angle, again not too long but not too short.
8. Prime your cotton by wetting it with e-liquid and adjust it's position. (Be sure to check the resistance of your coil before placing it under load. Furthermore check the coil's resistance periodically throughout it's usage to monitor for any changes.)
If you want to know informations about RDA,which is a rebuildable dripping atomizer, such as Bambino Atomizer, you can pay attentions to us, more good articles are waitting for you.